J-Log.eu - Forum

"Dumb test" before time consuming LA playing:

I'm using "SBS-01R*", non-existent 1-slot RPM sensor, as "filler" (manually registering) to occupy slots that I do not want that TEMP125 gets automatically registered to.
So all "gaps" between slots used by S32 got filled with sensors SBS-01R, - also all slots up to 24.

TEMP125 on slot 25, VARIO on 26-27.

That causes a different strange behavior: S32 slots up to 9 stop updating, all others still updated.
Now I remove TEMP125 from the sensor chain (disconnect) ==> everything is back working (except of the display for that TEMP125, of course).
VARIO (2-slot) is working under any condition, on any slot, never disturbing S32.

Quite sure, we found another bug in Futaba's crap, this time fortunately only in the firmware of one type of sensor, TEMP125-F1713.

_________________
Tom

Hi Tom

Not only SBS-01T but also "SBS-01RO Optical RPM Sensor" has the same issue.

About the LED show, after I put futaba sbus2 sensor and S32 working together, the LED show never happened until now.

thanks.

So my logic analyzer is looking forward.

_________________
Tom